The load values contained in this section are Hilti Simplified Design Tables. The load tables in this section were developed using the strength design parameters and variables of ESR-3814 and the equations within ACI 318-14 Chapter 17.
Mean ultimate resistance, characteristic resistance, design resistance, recommended loads. a) The allowed range of embedment depth is shown in the setting details. The corresponding load values can be calculated according to the simplified design method. a) With overall partial safety factor for action J = 1,4.
HIT-RE 500 V3 injection mortar Anchor design (EOTA TR029 & EOTA TR045) / Rods&Sleeves / Concrete Injection mortar system Benefits Foil pack: HIT-RE 500 V3 (available in 330, 500 and 1400 ml cartridges) - SafeSet technology: Simplified method of borehole preparation using either Hilti hollow drill bit for hammer drilling or Roughening
Hilti HIT-RE 500 V3 mortar w/ rebar (as post-installed conn.) Use the appropriate air nozzle Hilti HIT-DL. Blow two times from back of the hole over the hole length with oil-free compressed air until return air stream is free of noticeable dust. Safety tip: Do not inhale the concrete dust. Use of the dust collector Hilti HIT-DRS is recommended.
Mean ultimate resistance, characteristic resistance, design resistance, recommended loads.
Hilti HIT-RE 500 injection mortar may be applied in the temperature ranges given below. An elevated base material temperature may lead to a reduction of the design bond resistance.
Hilti HIT-RE 500 V3 mortar with HIT-V rod Static and quasi-static resistance (for a single anchor) All data in this section applies to: - Correct setting (See setting instruction) - No edge distance and spacing influence - Steel failure - Anchor HIT-V with strength class 5.8 and 8.8, anchor AM 8.8
Embedment depth and base material thickness for the basic loading data. Mean ultimate resistance, characteristic resistance, design resistance, recommended loads.
HIT-RE 500 V4 injection mortar Rebar design (EN 1992-1-1, EOTA TR 069, EN 1998-1) / Rebar elements / Concrete Injection mortar system Benefits HIT-RE 500 V4 using either Hilti hollow drill bit for (Available in 330-, 500- and 1400-ml Foil pack) - technology: Simplified method of borehole preparation hammer drilling or Roughening tool
Mechanical properties and dimensions of the rebars B500 B are standardized and can be taken from the ETA. Mechanical properties of the filling washer can be taken from the ETA’s listed in the table Approvals / Certificates. Short term loading.