These engine configurations are for the following Fuller® Automated Transmissions. (Note: Gear RPM Limits disabled in Drive.) Please work with an authorized Hino dealer to verify engine configuration. Note: For engine parameters not listed above, please refer to the engine manufactures programming guide.
Read the entire driver instructions before operating this transmission. Before starting a vehicle always be seated in the driver's seat, select “N” on the shift control, and set the parking brake. If engine cranks in any gear other than neutral, service vehicle immediately.
Construction detail of individual wiring harnesses including harness routing location and clipping points. Specifications for air dryer, air compressor and filter filtration systems. A high-level schematic of the pneumatic system supplying the transmission.
Eaton AutoShift transmission systems installed at OEM facilities must meet the requirements and be approved using the Eaton Transmission Application Approval Form. Please contact Eaton Application Engineering or your OEM's Application department for the latest Application form. 1. Space Requirements - Eaton AutoShift transmission systems ...
tons. Reference the transmission Driver Instruction Guide for details on Low mode and how it can be used to maximize engine braking. Changes to the transmission ECU config-uration requires Fleet approval and is typically done at a dealership. Condition: Transmission holds a gear instead of upshifting right after engine power-up or
Turn the ignition key to “ON” and allow the Fuller Advantage® Auto-mated Transmission to power-up. Start the engine. Apply service brake.
Installation guides | Driver Instructions - Eaton Cummins
Feb 27, 2020 · Updated service manual service parts and kits for clutch, input shaft, and transmission service units Download TAIB1003
Engine configuration - Prior to shipment of Eaton Transmi ssion Systems installed at OEM plants, the engine ECU must contain the proper configuration settings. For the proper engine configuration settings required for Eaton Transmission
Endurant HD V automated transmission - eatoncummins.com
The new Secondary Configuration mode gives drivers the ability to toggle between two Performance Goals for a tailored driving experience that accounts for the load or terrain. Efficient twin-countershaft design; Transmission fluid temperature and pressure sensor alerts driver before system damage occurs
Endurant HD 12-speed automated transmission - Eaton Cummins
Standard bottom mount and optional rear PTO mounts are available on Endurant HD 12-speed models, making them perfect for bulk haulers. New for the Endurant HD series are Performance Goals which combine transmission shift points and clutch calibrations with unique software.