What kind of glue can be used to join flat drive belt and v-belt?
Jul 22, 2011 · Rather than gluing the flat belt to the v-belt, what if you cut the flat belt (or some other material) into chunks, each of which is glued (or otherwise attached) to the flat belt. So, the "outer" surface of the track is not a continous flat belt, but is segmented.
adhesive - Should I remove old wood glue before reinstalling a …
Jan 31, 2019 · Agree 100% with removing the glue. However, disagree with the belt sander recommendation. A belt sander runs a high risk of removing more wood than glue. A simple paint scraper will do the job of scraping the glue off. Also agree with the comments on the OP about scraping the paint off before gluing again.
How do I remove THIN layer of carpet glue from concrete?
I tried using some adhesive remover we got from Lowe's, but it doesn't really seem to be having any effect other than making it wet : My local hardware stores include: Locke & Lowe's. There's also a local store that rents tools, but I'm not sure the extent of their selection, I was able to rent an auger there once for digging fence poles, just ...
Can I use self-levelling compound over old carpet adhesive?
Aug 17, 2022 · Can I use self-leveling compound over old carpet adhesive? I've ripped up the current carpets and found a couple of strips of very old carpet glue that are proving a NIGHTMARE to remove from the concrete. Do I have to? I'm going to use a primer, and then go about 4mm with the self leveller, and then put floating floorboards over the top of that.
What is this, and can my dryer work without it?
Jan 11, 2014 · You typically have to remove the front loading door assembly and the front housing of the dryer. (There may be other pre-steps to get to the point of being able to remove the front housing). Once you have access to the front of the drum it is easy to slide a new drive belt around the drum and onto the motor shaft and belt tightener/idler assembly.
How to remove clear adhesive tape from wooden kitchen …
Dec 12, 2024 · I have these annoying clear adhesive tape strips on a kitchen cupboard. I tried the following to remove them: Soap, then rub with pumice stone. It works but also scratches the surfaces. Heating it with a heat gun which should supposedly loosen the adhesive. Does not work at all. Rubbing isopropyl alcohol on it which should loosen the adhesive.
What adhesive should I use to glue rigid polystyrene insulation to ...
Dec 18, 2017 · Which glue/grab adhesive type to use with OSB 3 boards and joists for shed + spacing. 4.
Can landscape adhesive be used for a masonry fire pit?
Regarding Loctite PL 500 landscape adhesive (mentioned in the asker's answer)... Service Temperature: -20°F (-29°C) to 150°F (66°C) No, landscape adhesive (or at least that specific product) isn't rated for temperatures encountered in a fire pit.
Is there a high temperature glue that I can use on a cook top?
They do sell an adhesive for this; it's terribly expensive. Also, these rubber feet things are not covered by warranty, which may explain why not many other people discuss this; it's a part that's expected to fail, and people just ignore it. Personally, I …
New garage door opener belt sags when opening
May 22, 2016 · The belt needs to be connected with the tensioner loosened, so that the tensioner can be used to take up any excess slack. The specific procedure should be in the manual for your unit. But basically, assuming the belt is attached with enough slack removed, the tensioner bolt should be able to taske up the rest of the slack once tightened.